Brooks EIB650iWX, Руководство по эксплуатации и установке

Страница: 21 / 46

Operation & Installation Manual RFS1 V2
MA365 Rev 3
20 of 46
System
Main Control
(JP2 – Display Count)
Display Board
(JP1 – Address)
Single Display X1 #1
Dual Displays X2 #1 and #2
Notes:
1. Remote display module requires the same four wires, RS485 bus and
power.
2. Terminating resistor 1K Ohm must be fitted across the comms terminal of
RS485 bus.
3.6.1 Indicators
Table 4 RFS1 V2 Indictors
Descriptor Colour Function Buzzer
Power Green Steady On, mains power ok
Flashing, mains power off, system running on battery
No
Yes
Alarm Red Steady on for common alarm Yes
Defect Yellow
One blink, Zone circuit fault
Two Blinks, Strobe fault
Three blinks, Power supply fault
Steady On, Memory fault
Yes
Mute Yellow Alarms muted, 10 minutes timer running No
Locate Yellow Alarms located, 5 minutes timer running No
Test Yellow Steady On Yes
Ack Yellow Steady On No
3.6.2 Controls
Table 5 RFS1 V2 Control buttons
Descriptor Function
ACK Silences panel buzzer
Locate Identifies active Smoke / Heat Alarm causing fire
Mute Silences all active Smoke and Heat Alarms for 10 minutes
Test Activates Smoke / Heat Alarm sounders and panel buzzer
3.6.2.1 Fault Acknowledge
Pressing the Ack button will Silence the defect/fault buzzer, defect LED remains
illuminating and fault relay remains de-energised. A new fault condition will re-initiate
the buzzer. The defect LED and fault relay remain in fault condition until the fault
restores.
3.6.2.2 Alarm Locate
In alarm condition, all the Smoke/Heat Alarms sound, the “ Locate ” LED flashes to
prompt the occupant to press the button and identify the location of the alarm origin.
Pressing the “ locate ” button once silences all the Smoke/ Heat Alarm sounders
except those that have been activated. This function allows the occupant to identify
the location of alarm by listening to the Smoke/Heat Alarm sounder. Automatically
resets after approximately 5 minutes. If the Smoke/Heat Alarm has been identified