BROOD DRNX DUO, Руководство пользователя

Страница: 6 / 16

6 DRNX DUO BY BROOD
INSTALLATION
1. Install on a clean and dry surface.
Allow no less than 5 centimetres of space from all sides.
2. Assemble the tap handles.
3. Plug the power cord into an electrical outlet. Connect both beverage tubes
to DRNX by pushing the elbow fittings into the connections underneath
the machine.
Tilt the machine slightly if you need to. If you need to release a beverage
tube, push the metal spring next to the connection underneath.
4. Connect the beverage tubes to the pre-filters.
Make sure the arrow at the base of the pre-filter is pointing in the direction
of the flow.
WARNING: If you do not use the pre-filter, the following problem
may occur:
Blockage in the machine due to large coffee particles.
Make sure all tubes are pushed firmly in place.
Connecting to the designated BROOD container.
1. Pour your beverage into the designated container.
Close the lid and push the seal.
2. Push one of the elbow fittings into the connector at the bottom of
the container. And push the other fitting into the connecter at the bottom
of the machine.
3. Make sure the arrow at the base of the pre-filter is pointing in the
direction of the flow.
Connecting to any container.
1. Pour your beverage in any container.
2. Push the elbow fitting into the connecter at the bottom of the machine.
3. Drop the loose end of your beverage tube into the container containing
your beverage.
4. Make sure the arrow at the base of the pre-filter is pointing in the direction
of the flow.
DRNX will pull from any container. If using a keg, then attach your beverage tube
to a keg coupler. If using a bag-in box, then attach your beverage tube to a bag-in-
box adaptor.
WARNING: Liquid containing solid matter cannot be used.
WARNING: Never run hot liquid above 30 °C (86 °F) through DRNX.
!
!
SETUP
CONNECT TO CONTAINER
CONNECTOR CONNECTOR
PRE-FILTER
BROOD
CONTAINER
CONNECTOR
PRE-FILTER
ANY CONTAINER
NO CONNECTION
LOOSE TUBE