brondell RC100, Руководство пользователя, Страница: 22 / 88

20
Problem Possible Cause Solution
My TDS meter is not
reading zero It could be normal operation or the filters
may need to be changed
Generally, RO systems lower TDS readings
by 90% as compared to tap water readings.
This is a normal working range. For example,
if your tap water TDS reading is 100, then a
normal TDS reading for the RO filtered water
is in the range of 0–10. If the TDS reading for
the RO filtered water is higher than 15% of
normal tap water, this indicates it time for a
filter change (including RO membrane).
No water, not enough
water, or low water
flow
Incoming water supply valve is turned off Turn on incoming water supply valve
Low incoming water pressure
Verify pressure is above 40 psi; install a
booster pump if needed
Capacity is exhausted
Allow time for the Circle to replenish the
water tank
Plumbing restriction
Check connections and tubes for
obstructions
Other filter or RO membrane is clogged See Filter Replacement (page 16)
Internal valve is inoperative
See product warranty in last page of manual
and contact Brondell
Unexpected flow in
drain line
Internal valve is inoperative
See product warranty in last page of manual
and contact Brondell
No drain flow
Other filters or RO membrane (3) is clogged See Filter Replacement (page 16)
Internal regulator is inoperative
See product warranty in last page of manual
and contact Brondell
Bad tasting water
Post Carbon Block Filter is exhausted See Filter Replacement (page 16)
Newly replaced Post Carbon Block Filter
is not flushed completely
Open the provided faucet and drain the
water tank once. Flush one or two tanks
of treated water through the Post Carbon
Block Filter
Problem with the water tank bladder
See product warranty in last page of manual
and contact Brondell
Cloudy water Dissolved air in incoming water supply
Problem should clear up as the condition of
the incoming water changes. Letting water
stand will allow the dissolved air to dissipate
Leaking water from
the Circle
Tube is not fully inserted into a connec-
tion Make sure the tube is at least 1/2-inch into
the connection
Filter is not installed correctly
Ensure that all four filters are locked into
place
Unusual sounds during
operation Problem with one of the internal
regulators See product warranty in last page of manual
and contact Brondell
TROUBLESHOOTING
If the Circle experiences difficulties, close the T-valve to shut off the incoming
water to the Circle.