Bromic Heating MEDIFRIDGE MEDO220GD, Инструкция по эксплуатации

Страница: 8 / 15

1300 276 642 www.bromic.com/refrigeration
8
5. OPERATION
Start-up
• Connect the appliance to the mains power supply and check that the compressor,
electronic controller, lighting and all fans are functioning correctly.
• The compressor and condenser fan should operate should operate 3 minutes after the
unit has been connected to the power supply.
• The evaporator fan should operate after the unit has been plugged in.
• The electronic controller will display the current cabinet temperature after the unit has
been connected to the power supply.
• The LED indicates that refrigeration circuit is operating.
• During the start-up delay (3 minutes), the LED is flashing
• The LED indicates that the refrigeration circuit is defrosting
Setting the temperature
NOTE:
The controller is factory set at 4°C. The controller is programmed to control cabinet
temperatures between 2 to 8°C.
i. Press the button for more than 2 seconds.
ii. The value of the set point will be displayed and the ‘°C’ or ‘°F’ LED starts blinking.
iii. Press or arrow key within 10 seconds to adjust the set point.
iv. Press the key again or wait 10 seconds.
Operating the light
i. Set the 0-1 switch to the ‘1’ position.