5
INSTALLATION INSTRUCTIONS
1 This is a freestanding appliance and must not be built-in. In the event that the appliance is installed
near combustible material, the following minimum clearances must be maintained.
- a minimum distance of 200mm must be maintained from the centre of the top gas burners to any
combustible surface on each side and on the back of the cooker
2. Do not install the cooker below combustible materials - minimum clearance to overhead
cupboard 600mm.
3. Check the “Gas Type” sticker attached to the cooker. Details of the injector size and gas used are
recorded on the rating plate located at the left hand rear next to connection point.
4. This appliance shall be installed in accordance with the installation requirements of the local authority
or the appropriate gas installation code AS5601. For installations in caravan, mobile homes & marine
vessels the cooker rear bracket is to be screwed in place to minimize movement and vibration. If the
appliance is not securely fixed, movement and vibration may result in strain on the appliance
connection which can result in a safety hazard (See Table 1).
5. Before installing the cooker consider the location of the gas supply and routing of gas line. Inlet
connection is at the left rear of the cooker, 60mm from left rear corner, 105mm from the floor. Overall
dimension of cooker
Width 480mm
Height 175mm
Depth 290mm
6. For LPG models the gas supply for the cooker must be regulator to a pressure of 2.75 Kpa. The gas
inlet connecting pipe has a (5/16” SAE) male thread. Where an AGA approved hose assembly is used
the maximum hose length of the hose assembly is to be 1200mm. The hose assembly is to be
restrained from accidental contact with the flue outlet of an under bench oven.
7. A manual shut for valve must be installed in the gas line, in an accessible position external to the range
so that in the event of an emergency or service, the gas supply can be shut off.
8. After installing the gas supply and making all connections, check thoroughly for possible leaks. Turn
all control knobs on the unit to “OFF” position, open the valve on the supply tank, using a soap and
water solution check each gas connection one at a time by brushing the solution over the connections.
The presence of bubbles indicates a leak. Tighten the fitting and re-check for leaks. If no bubbles are
detected proceed to point 9.
If bubbles still persist, turn off the gas supply and contact your place of purchase. DO NOT check for
leaks by using a lighted match or naked flame.
9. Turn on the appliance control valve and light each burner. Check for a clean blue flame without yellow
tipping. If burners show any abnormalities, check that they are located properly and in line with the
injector nipple.
10. Sometimes the burner will not ignite immediately and seems to “blow” slightly when they do not
ignite. This is usually due to air in the gas lines, which will clear within seconds.
11. If after following these instructions, satisfactory performance cannot be obtained contact the local
gas authority for advice and assistance.
