1.
2.
INSTALLATION INSTRUCTIONS
4.
3.
Please read all of the instructions and look at the pictures before attaching the holder.
1. To adjust the holder for your device: Loosen the screws on the back side of the holder, so the sides of the
holders can be adjusted. Place the device in the holder and press the sides together so the device is firmly in
place.
2. Tighten the screws on the back side of the holder. To install the holder: Loosen the screw in the center of the
holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired
position. Screw the attaching plate into place with the enclosed screws.
3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the
screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time
tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place,
but still can be adjusted. All cables that fit the device, can be connected to the holder.
4. The holder is in place.
2 (2)
