• It may be present at a temperature of room temperature and not higher than 30 ° C;
• It is no longer than 1500mm;
• It can not be constrict;
• It should not be subjected to drawing or a force of;
• It should not be exposed to sharp edges and corners;
• It does not crack appeared cuts, burning feet pipe ends or the entire length,
• The material is not cured, it is still flexible,
• Fixing clamp is not corroded,
• The period of validity has not expired.
USE OF GAS STOVE
Be sure to use a new rubber hose. Do not use a vinyl hose because it is susceptible to heat and
non-elastic. Insert the rubber hose securely and fasten it tightly with a hose clip. Open the main
gas valve. Push the flame regulator and ON/OFF switch and turn it counters anticlockwise to the
ON position,use burning torch on burner. To adjust the flame, turn the gas control knob to a
suitable position between ON and OFF; be careful when turning the flame regulator toward OFF,
as the flame may go out.
TECHNICAL INFORMATION
Gas category
I
3+(28-30/37)
Declared heat input
G30 at 28-30mbar
or G31 at 37 mbar
Setting pressure
Main burner injector
size
Small burner injector
size
Burner type
Aeration setting
Inlet connection
I
3B/P(30)
ΣQn= 3.4 kW( 248g/h)
2 trapezoid - high (8mm), upper line (8mm), lower line (10mm)
Connection to suit country of destitantion
Inlet pressure
G30 and G31 at 30 mbar
As noted above
0,68mm (Marked 0,68)
0,75mm (Marked 0,75)
Single burner comprising a die cast aluminium alloy body
Trademarks BROCK Electronics owner GTCL BALTIC
Phone: +371 67297762
E-mail: [email protected]
www.brockgroup.eu
www.gtcl.eu
Technical Service: Tel. +371 28683856, [email protected]
GB