Broce Broom BB-250 Series, Инструкция по обслуживанию, техническому обслуживанию и запасным частям

Страница: 23 / 54

LUBRICATION AND MAINTENANCE
1. Grease two steering shaft bearings at the front of the machine every day.
2. The front wheel bearings should be cleaned and packed every six months.
3. The tires on the front and rear of the machine should be kept at 32 psi and should be checked on a
daily basis. When a tire (or tires) needs to be replaced, make sure the replacement tire is the same
type and height as the remaining tire (tires) on the machine. This will keep the sweeping core level.
4. The battery should be checked once a month. Use distilled water only to bring the fluid level up to
the required height. Keep battery post and cables clean. Battery requirements are: 12v, 70AH or
equivalent.
5. The radiator should be checked for dirt build up every 4 to 8 hours. Use water or compressed air
directed from the engine side of the radiator to remove excess dirt. A mixture of 50% water and
50% permanent antifreeze should be used in the radiator thru the entire year. Check the mixture
and fluid level at least once a week. The fluid level should be ½ full on the side of the over flow
tank.
6. Engine oil should be checked once per day. Engine oil type should be: 10w30, MIL-L-21046 or
CD (API spec.) equivalent or above. Oil pan capacity is 7 quarts. The oil and oil filter should be
changed after the first 50 hours and every 150 hours thereafter. All other filters, air, spin-on fuel
and in-line fuel should be changed every 150 hours. Pre-Cleaner bowl at the top of the air inlet
tube should be emptied and cleaned daily. Use only diesel fuel NO.2-D (ASTM D975).
7. The fuel tank should be drained once a year. The fuel tank drain is located in the back of the fuel
tank.
8. The water system (for dust control) should be inspected daily. Clean the water filters, the spray
nozzles and the screen inside the nozzle head daily.
9. The wheel lock-out hub oil level should be checked every three months. Remove the female hex
plug on front or back of the housing to check, the oil level should be up to this hole. If oil needs to
be added use a 10w40 non-detergent motor oil. Capacity of this hub is approx. ½ pint or 8oz.
10. Hydraulic oil should be checked daily. Oil should be to the full mark on the gauge at the right side
of the hydraulic tank. Change hydraulic oil every six months or as needed. Hydraulic oil type:
(CITGO TRANSGARD TRACTOR HYDRAULIC FLUID), (MOBIL 424) or equivalent. Change
both spin-on hydraulic filter (under hood to the left of the engine) and the high pressure filter
(under the hood, to the right and forward of the engine) every three months or every 500 hours,
which ever comes first.
16
Go
to
Discount-Equipment.com
for
parts