Brocade Communications Systems TurboIron 24X series, Руководство по установке оборудования

Страница: 45 / 82

Brocade TurboIron 24X Series Hardware Installation Guide 35
53-1001378-01
Removing MAC address entries
4
To change the device poll time, enter a command such as the following at the global CONFIG level
of the CLI.
TurboIron(config)# chassis poll-time 200
Syntax: chassis poll-time <value>
NOTE
The <value> can be 0 - 65535.
Removing MAC address entries
You can remove learned MAC address entries from the Brocade system MAC address table. You
can remove the following entries:
•
All MAC address entries
•
All MAC address entries for a specified Ethernet port
•
All MAC address entries for a specified VLAN
•
A specified MAC address entry in all VLANs
For example, to remove entries for the MAC address 000d.cb80.00d in all VLANs, enter the
following command at the Privileged EXEC level of the CLI.
TurboIron# clear mac-address 000d.cb80.00d0
Syntax: clear mac-address <mac-address> | ethernet <port-num> | vlan <number>
If you enter the clear mac-address command without any parameters, the software removes all
MAC entries.
Use the <mac-address> parameter to remove a specified MAC address from all VLANs. Specify the
MAC address in the following format: HHHH.HHHH.HHHH.
Use the ethernet <port-num> parameter to remove all MAC addresses for a specified Ethernet
port.
Use the vlan <number> parameter to remove all MAC addresses for a specified VLAN.