Brocade Communications Systems ICX 6650 series, Руководство по установке оборудования

Страница: 43 / 83

Configuring the Brocade ICX 6650
• Assigning permanent passwords................................................................................................................................................................43
• Configuring IP addresses............................................................................................................................................................................... 44
• Connecting network devices......................................................................................................................................................................... 48
• Testing connectivity.......................................................................................................................................................................................... 49
• Troubleshooting network connections......................................................................................................................................................49
Assigning permanent passwords
By default, the CLI is not protected by passwords. To secure CLI access, Brocade strongly recommends assigning passwords. Refer to
the
FastIron Ethernet Switch Administration Guide .
You can set the following levels of Enable passwords:
• Super User - Allows complete read-and-write access to the system. This is generally for system administrators and is the only
password level that allows you to configure passwords.
NOTE
You must set a Super User password before you can set other types of passwords.
• Port Configuration - Allows read-and-write access for specific ports but not for global (system-wide) parameters.
• Read Only - Allows access to the Privileged EXEC mode and CONFIG mode but only with read access.
Setting passwords
1. At the opening CLI prompt, enter the following command to change to the Privileged EXEC mode:
device> enable
2. Access the CONFIG level of the CLI by entering the following command:
device# configure terminal
device(config)#
3. Enter the following command to set the Super User password:
device(config)# enable super-user-password text
NOTE
You must set the Super User password before you can set other types of passwords.
Brocade ICX 6650 Hardware Installation Guide
Part Number: 53-1003621-04 43