Brocade Communications Systems ICX 6650 series, Руководство по установке оборудования

Страница: 45 / 83

2. Enter the following command at the Privileged EXEC level prompt, then press Enter . This command erases the factory test
configuration if still present.
device# erase startup-config
CAUTION
Use the erase startup-config command only for new systems. If you enter this command on a system you have
already configured, the command erases the configuration. If you accidentally do erase the configuration on a
configured system, enter the write memory command to save the running configuration to the startup-config file.
3. Access the configuration level of the CLI by entering the following command:
device# configure terminal
device(config)#
4. Configure the IP addresses and mask for the switch.
device(config)# ip address 192.168.0.0 255.255.255.0
5. Set a default gateway address for the switch.
device(config)# ip default-gateway 192.168.0.0
NOTE
You do not need to assign a default gateway address for single subnet networks.
Devices running Layer 3 software
Before attaching equipment to a Brocade ICX 6650, you must assign an interface IP address to the subnet on which the router
connected to the switch will be located. You must use the serial connection to assign the first IP address. For subsequent addresses, you
also can use the CLI through Telnet or the Web management interface.
By default, you can configure up to 24 IP addresses on each port, virtual interface, and loopback interface. You can increase this amount
to up to 64 IP subnet addresses per port by increasing the size of the subnet-per-interface table.
The following procedure shows how to add an IP address and mask to a router port.
1. At the opening CLI prompt, enter enable .
device> enable
2. Enter the following command at the Privileged EXEC level prompt, and then press Enter . This command erases the factory test
configuration if still present.
device# erase startup-config
CAUTION
Use the erase startup-config command only for new systems. If you enter this command on a system you have
already configured, the command erases the configuration. If you accidentally do erase the configuration on a
configured system, enter the write memory command to save the running configuration to the startup-config file.
3. Access the configuration level of the CLI by entering the following command.
device# configure terminal
device(config)#
Configuring IP addresses
Brocade ICX 6650 Hardware Installation Guide
Part Number: 53-1003621-04 45