Brobo Group
brobo.com.au
3) Change coolant as required, or whenever the coolant starts to get dirty or emits a stale odour. The coolant
compensation tank should be checked regularly. Coolant level would expect to naturally decrease over time
due to natural evaporation. Use premium quality coolants such as CoolTech 500 or SlideTech 68.
Coolant is available from
BROBO GROUP
Pty. Ltd. in 2 litre & 20 litre packs (Part No.
9301570
&
9501080
):
Concentrate, Ratio 1:20
4) Lubricate the saw head pivot shaft & rotary table regularly (after every 40 hours of operation, or weekly) with
an NLGI 2 extreme pressure grease, Shell Alvania No.1 grease or equivalent.
5) Clean the vice & lubricate any moving joints or sliding surfaces with good quality oil.
6) Clean the machine regularly & keep any unpainted surfaces lightly oiled to protect from rust & corrosion.
7) The air supply for the pneumatic air vices should be checked regularly such that it is free of any condensed
water molecules & the filter should be drained frequently.
8) Ensure that the machine performs cuts perpendicular to the work surface.
If not, contact
Brobo Group
engineering department.
9) Test that the blade is at right angles to the workpiece back fence.
If not, contact
Brobo Group
engineering department.
10) Check that the 0
notch on the fixed worktable is aligned with the graduation on the turntable. If not, adjust
as described in Section 5.2.
11) Examined that the precision of the 15
, 30
, 45
left & right stops are correct & accurate. If they are not
adjusted properly, proceed as described in Section 5.2.
12) Regularly empty out the swarf catcher, resting directly above the compensation tank, of any offcuts & swarf
that has collected during the numerous cutting cycles.
