Broaster 620NXP, Руководство по эксплуатации

Страница: 14 / 18

4–2
DRIVE MOTOR REPLACEMENT
1. Disconnect power cord.
2. Remove screws (2) from control box.
3. Remove bridge pin (4) and mounting
screws (5).
4. Disconnect motor wiring and pull out
defective motor.
5. Install new motor by sliding the drive
shaft through the hole in the box and
into the end of the wheel shaft.
6. Install mounting screws (5).
7. If the new motor does not have a hole
in the shaft for the bridge pin, using
the hole in the wheel shaft, drill a 1/8”
diameter hole through the motor drive
shaft.
8. Insert the bridge pin (4).
9. Rewire the motor (see wiring diagram
on page 2-1).
10. Reinstall the control box cover with
screws (2).
11. Reconnect power cord.
broaster.com Manual #17142 1/12 Rev: 2/14