MODELS QP430SS • QP436SS • QP442SS
Page 2
OPERATION
Always turn the hood ON before cooking in order to establish an
air flow in the kitchen. After turning off the range, let the hood run
for a few minutes to clear the air.
Operate the hood as follows:
NOTE
The and
buttons are used to adjust and toggle the menu
and timer settings.
LIGHT (3-Pushbutton Switches 4-light Settings)
Turns the light on the low setting and activates a green indicator
above the button. Pressing the button a second time activates the
night time setting and illuminates the indicator.
Turns the light on the medium setting and activates a green
indicator above the button.
Turns the light on the high setting and activates a green
indicator above the button.
Pressing and holding the same light button again will turn the lights
off.
When the night time setting is active, pressing and holding the low
light setting button will turn the night time setting off.
FAN (3-Pushbutton Switches 4-fan speeds)
Turns the fan on the low speed and activates a green indicator
above the button.
Turns the fan on the medium speed and activates a green
indicator above the button.
Turns the fan on the high speed and activates a green indicator
above the button. Pressing the
button a second time activates
the boost fan speed and illuminates the
indicator.
Pressing and holding the same fan button again will turn the fan off.
When the boost speed is active, pressing and holding the high
speed button will turn the boost speed off.
NOTE
This hood utilizes an offset blower design to achieve greater
performance and lower sound levels. As a result, you may notice
that cooking impurities are more attracted to one side or appear
to be pulled-in faster than they appear on the opposite side. This
is completely normal. The hood has been designed and tested
to provide good capture of cooking impurities and odors under
all normal cooking conditions regardless of the cooking location
on the cooktop. Please note that cooking on the rear burners will
always result in the best capture of cooking impurities, regardless
of the hood design.
CLEANING & MAINTENANCE
For performance, appearance, and health reasons, clean filter,
fan and grease-laden surfaces. Use
only
a clean cloth and mild
detergent solution on stainless and painted surfaces.
Clean all-metal filters in the dishwasher using a non-phosphate
detergent. Discoloration of the filter may occur if using phosphate
detergents, or as a result of local water conditions - but this will
not affect filter performance. This discoloration is not covered by
the warranty.
The motor is permanently lubricated and never needs oiling. If
the motor bearings make excessive or unusual noise, replace
the motor with the exact service motor. The impeller should also
be replaced.
Use 120 V, 50 W, shielded halogen bulbs - MR16 with GU10 base.
CONTENTS
GREASE
FILTERS
(2 - FOR 30” & 36” HOODS)
(3 - FOR 42” HOODS)
(1) 3¼” X 14”
DAMPER / DUCT
CONNECTOR
(1) 7” ROUND
DUCT
CONNECTOR
(4)
HALOGEN
BULBS
(1)
BULB
SUCTION
CUP TOOL
(1) PARTS BAG CONTAINING:
(3)
WIRE
NUTS
INCLUDED WITH THE HOOD:
(9)
#8 X 1/4”
DUCT
CONNECTOR
SCREWS
(5)
#10 X 5/8”
RD. HD.
MOUNTING
SCREWS
(1) VERTICAL
AIR DIVERTER
