INST
ALLA
TION MANUAL
OPERA
TION
5
Operation
Always turn your hood on before you begin cooking to establish an air flow in the kitchen.
Let the blower run for a few minutes to clear the air after you turn off the range. This will help
keep the whole kitchen cleaner and fresher.
Operate the hood as follows:
BLOWER ACTIVATION/SPEED LEVEL CHANGE/FILTER INDICATOR RESET
When blower is OFF, press on this push button to turn ON the blower at the last saved speed. If
there was no speed saved, the blower will be set on LOW speed.
NOTE: When LOW speed is activated from OFF, the blower starts on MEDIUM speed for a very
short lapse of time, and then resume to LOW speed.
To change the blower speed, press on this button again until the desired speed is reached (from
LOW to MEDIUM to HIGH speed to OFF). Each time a blower speed is activated, a rotating blower
icon appears on left side of LCD screen, with dot(s) under it (slow for LOW with one dot, faster for
MEDIUM with 2 dots and fastest for HIGH with 3 dots).
When blower is on (no matter the speed level), press and hold this button until the blower icon
disappears from the LCD screen; this will turn off the blower and save the blower speed chosen.
Heat Sentry™
This hood is equipped with a protective device that activates the blower when an abnormally high
heat level is detected while the blower is activated. During the Heat Sentry activation, this device
takes control of the blower and set it on MEDIUM speed while all dots under the blower icon blink.
However, the lights can be still controlled. The blower will remain on MEDIUM speed until the heat
is back to normal, it then returns to the speed previously selected.
NOTE: When excessive heat is detected, Heat Sentry will shut off both blower and lights while
all dots under the blower icon will blink faster. Both blower and lights will remain off until
the ambient temperature cools down; the blower will then start on MEDIUM speed (the
lights can be controlled again). The blower will remain on MEDIUM speed until the heat is
back to normal, it then returns to the speed previously selected.
NOTE: At range hood start-up or after a power failure, a small icon (
1
) appears shortly
(for ± 2 seconds) on LCD screen; this is normal.
FILTER CLEANING REMINDER
This icon appears on LCD screen 30 seconds after turning OFF the blower when it is time to clean
hood and filters (refer to Cleaning and Maintenance on page 7). This happens every time the
blower is turned OFF until the filter cleaning reminder has been reset. Once the cleaning is done,
reset the filter cleaning reminder by pressing on blower activation push button for 3 seconds while
the icon appears on LCD screen for 30 seconds.
1
