Quick Start Guide
Download Optocore Control Software V 2.21.019
from www.optocore.com/downloads
CONNECTIVITY
VIDEO
* BNC Ports 1-4 – 3G/HD-SDI Inputs with reclockers (patched to outputs 5-8 on the second unit)
* BNC Ports 5-8 – 3G/HD-SDI Outputs (patched to inputs 1-4 on the second unit)
INTERCOM
* TO PANEL 1-4 – four 4-wire ports to be connected with a straight Cat5 cable to four Clear-Com
panels
* TO MATRIX 1-4 – four 4-wire ports to be connected with a straight Cat5 cable to four panel ports on a Clear-
Com
matrix
Ports TO PANEL and TO MATRIX work in parallel; the only difference between them is pinout. Use only one of
both ports - either to panel or to matrix.
Ports on two Mux22 devices are patched 1:1. Patching can be changed in Optocore Control Software.
Detailed pinout can be found in the Mux22 Operating Manual.
ETHERNET
* LAN 1-2 – 2 x RJ45 LAN ports
* SANE 1-2 – 2 x RJ45 SANE (audio over Cat5 by Optocore) / LAN ports
Fiber connection between two units creates 8-port unmanaged 100Mbit Ethernet switch.
GPIO
* RS485/GPIO – 4 x GPI, 4 x GPO ports on D-SUB-15 connector
Four bi-directional GPIO ports are patched 1:1 between two Mux22 devices. Patching can be changed in
Optocore Control Software.
Detailed pinout can be found in the Mux22 Operating Manual.
AUX
* AUX 1 – 1310nm fiber tunnel, not dependent on protocol or bandwidth
Aux port can be used in example for 1G or 10G Ethernet tunnel or any closed 3rd party protocol.
SYNC
* Sync IN – configurable Sync Input (Tri-Level-Sync, Blackburst or Word Clock)
* Sync OUT – configurable Sync Output (Tri-Level-Sync, Blackburst or Word Clock)
By default device with ID1 is the Sync Master. External Sync source should be connected to Sync IN on ID1.
Default Sync setup is Bi-Level blackburst NTSC IN and OUT.
Sync Mode can be changed in Optocore Control Software.
COM
* COM 1 – fiber combined port which carries all video, intercom and data signals
