3 |
P a g e
© Broadfeet Motorsport Equipment
STEP4: Cutting on the plastic area shown on Fig3 for approximately 1” wide and 2” long.
STEP5: As shown on Fig4, first remove the factory screw on the right (Marked: A) and then
remove the factory screw on the left (Marked: B). Hold the skid shield while sliding the Driver
Side Mounting Bracket into the 3”X5”opening.
STEP6: Apply WD-40 on the factory screws. And firstly put back the screw on the left [Marked:
B], secondly put back the screw on the right [Marked: A]. Lastly, put back the factory screw
removed from step2 [Marked: C]. (Fig4)
Fig 3
Fig 4
2”
1”
A
B
C
