1 |
P a g e
© Broadfeet Motorsport Equipment
Qty Hardware
2
Mounting Brackets
4
Screw
8
Flat Washer
Lock Washer
Nut
INSTALLATION INSTRUCTIONS
2014-2015 ACURA MDX
A-BAR PART# DCAC-114-32
Страница 1: ...1 P a g e Broadfeet Motorsport Equipment Qty Hardware Qty Hardware 2 Mounting Brackets 4 Screw 8 Flat Washer 4 Lock Washer 4 Nut INSTALLATION INSTRUCTIONS 2014 2015 ACURA MDX A BAR PART DCAC 114 32 ...
Страница 2: ...all parts are present Read instructions carefully before starting installation STEP2 Starting from the Driver Side remove the factory screw shown on Fig1 STEP3 Cutting on the skid shield for approximately 3 wide and 5 long as shown on Fig2 Fig 1 3 5 Fig 2 ...
Страница 3: ...ight Marked A and then remove the factory screw on the left Marked B Hold the skid shield while sliding the Driver Side Mounting Bracket into the 3 X5 opening STEP6 Apply WD 40 on the factory screws And firstly put back the screw on the left Marked B secondly put back the screw on the right Marked A Lastly put back the factory screw removed from step2 Marked C Fig4 Fig 3 Fig 4 2 1 A B C ...
Страница 4: ...cket installation STEP8 Select the A Bar and install it on the mounting brackets using 2 Screws 4 Flat Washers 2 Lock Washers and 2 Nuts on each side Tighten all hardware at the end to finish the installation Fig5 Fig6 Fig 5 Fig 6 Driver Side installation finished Driver Side installation finished ...
