Broadcom SAS 9305-16i, Руководство пользователя

Страница: 10 / 12

Broadcom
- 10 -
SAS 9305-16i PCI Express to 12Gb/s SAS Host Bus Adapter User Guide
June 17, 2016 Chapter 1: SAS 9305-16i Host Bus Adapter User Guide
Technical Support
3. Keep the board on a level surface to make sure you do not lose any retaining clips. The heat sink is held in
place by the same screws that attach the bracket. The black retaining clips shown in the following figure can come
loose when the screws are removed.
Figure 4 Heat Sink Held in Place by Retaining Clips Attached by Bracket Screws
CAUTION Do not move or rock the heat sink after you remove the bracket
screws. Doing so might damage the thermal interface material, which
causes the board to overheat during operation. Damage to the heat
sink or the interface material while changing the bracket might void
the board warranty.
4. Place the HBA on top of the replacement bracket. Place the HBA on top of the replacement bracket. Make sure
to position the bracket so that the screw holes in the tabs are aligned with the openings in the board as shown in
the following figure.
Figure 5 Replacing the Bracket
5. Use an ESD-safe #1 Phillips torque screwdriver to set the screws to a maximum torque of 4.8 ± 0.5
inch-pounds to replace the two Phillips screws that you removed in step
2 .
6. Replace the board in its ESD-protective bag, and seal the bag appropriately.
ATTENTION Exceeding this torque specification can damage the board,
connectors, or screws, and can void the warranty on the board.
1.10 Technical Support
For assistance installing, configuring, or running the 12Gb/s SAS HBA, contact Technical Support at
http://www.avagotech.com/support/ .