Broadcom
- 4 -
MegaRAID SAS 9361-4i and SAS 9361-8i RAID Controllers Quick Installation Guide
March 9, 2018
MegaRAID
®
SAS 9361-4i and SAS 9361-8i RAID Controllers Quick Installation Guide
Installing the MegaRAID SAS 9361 RAID Controller
ATTENTION
Damage caused to the RAID controller as a result of changing the
bracket can void the warranty on the RAID controller. RAID controllers
returned without a bracket mounted on the board will be returned
without return merchandise authorization (RMA) processing.
4.
Install the RAID controller.
Insert the RAID controller into a PCIe slot on the motherboard in the host computer,
as shown in the following figure. Press down gently, but firmly, to seat the RAID controller correctly in the slot.
Secure the RAID controller to the host computer chassis with the bracket screw.
NOTE
This RAID controller is a PCIe x8 card, and it can operate in x8 or x16
slots. Some PCIe slots, however, support only PCIe graphics cards; if a
RAID controller is installed in one of these slots, the RAID controller will
not function. Refer to the guide for your motherboard for information
about the PCIe slot.
Figure 1 Installing the MegaRAID SAS 9361-8i RAID Controller
5.
Configure and install the SAS devices, SATA devices, or both in the host computer case.
Refer to the device
documentation for any preinstallation configuration requirements.
6.
Connect the RAID controller to the SAS devices, SATA devices, or both in the host computer case.
Use SAS
cables to connect the RAID controller to SAS devices, SATA devices, or both. Refer to
12Gb/s MegaRAID SAS RAID
Controllers User Guide
for information about the connector locations.
7.
Turn on the power to the host computer.
Reinstall the computer cover, and reconnect the power cords. Turn on
the power to the host computer. Make sure that the power is turned on to the SAS devices and the SATA III devices
Edge of
Motherboard
PCIe Slot
Bracket
Screw
Press
Here
Press
Here
3_01495-02
Содержание MegaRAID SAS 9361-4i
Страница 8: ......
