MegaRAID SAS 9361-24i RAID Controller Quick Installation Guide
February 20, 2017
Driver Installation
Figure 2
. Create New Virtual Drive Screen
Install
ing the Driver
All driver installation instructions are available at
https://www.broadcom.com/support/download-search
Access this site, then select
Storage Adapters, Controllers, and ICs > All Storage Adapters,
Controllers, and ICs > MegaRAID SAS 9361-24i > Driver.
Replacing the Bracket on the MegaRAID SAS 9361-24i RAID
Controller
To replace the bracket on the Broadcom 12Gb/s SAS RAID controller, follow these steps:
1.
At an ESD-safe workstation, remove the controller from its ESD protective bag.
ATTENTION:
Never apply pressure to the bracket or the heat sink when inserting the controller. Do not
handle the controller by the bracket. Do not handle the heat sink at any time. Do not bend
or twist the controller at any time.
2.
Use an ESD-safe #No.1 Phillips screwdriver to carefully remove the two Phillips screws that
connect the bracket to the controller.
The following figure shows how to unscrew the two screws
located at the top edge and bottom edge of the controller.
ATTENTION:
Damaging the screw can void the warranty. To prevent damage to the screw, make sure
that the screwdriver is centered in the top of the screw.
