Broadcom Emulex LPe31000, Быстрое руководство по установке

Страница: 14 / 26

Broadcom LPe3X00X-IG114-101
14
Emulex LPe31000-Series and LPe32000-Series Adapters Quick Installation
Guide
2.7 Changing the Speed of the Adapter
On some adapters, the speed of the link can be changed from 16GFC to 32GFC or from 32GFC to 16GFC by replacing the
optical transceivers. The transmission speed of the LPe31000-series and LPe32000-series adapters can be changed in this
way.
2.8 Setting the Secure Firmware Jumper
The LPe31000-series and LPe32000-series adapters have a jumper that enables or disables the Secure Firmware feature
as required.
To update the firmware using a tool, such as the OneCommand
®
Manager application, boot utilities, or Elxflash utilities, there
is no need to remove the jumper; the Secure Firmware feature can remain enabled as long as the update is from a secure
firmware version to another secure firmware version. To change the firmware version from a secure firmware version to an
unsecured firmware version, you must first remove the jumper before updating the firmware.
Replace the jumper after the firmware update is complete.
The following illustrations ( Figure 8 and Figure 9 ) provide examples of common locations of the Secure Firmware jumper.
On Off Failure in common code module
On On Failure in common code module
On 2 Fast blinks Normal (link up at GFC)
On 3 Fast blinks Normal (link up at 8GFC)
On 4 Fast blinks Normal (link up at 16GFC)
On 5 Fast blinks Normal (link up at 32GFC)
On Flashing Not defined
Slow blink Off Normal link down
Slow blink On Not defined
Slow blink Slow blink Not defined
Slow blink Fast blink Not defined
Slow blink Flashing Not defined
Fast blink Off Not defined
Fast blink On Not defined
Fast blink Slow blink Not defined
Fast blink Fast blink Beaconing
Fast blink Flashing Not defined
Table 6: POST Conditions and Results (Continued)
Green LED Yellow LED State