Broadcom Brocade X6-4, Руководство по установке

Страница: 38 / 208

53-1004106-15 Installation Guide Brocade
®
X6-4 Director Hardware Installation Guide
3. 6-32 x .25 in. (.635 cm) Phillips screw
4. 10-32 x .5 in. (1.27 cm) Phillips screw with blue Loctite on threads or 10-32 x .63 in.(1.60 cm) Phillips
screw with square cone washer for racks that have rails with round holes
6. Secure the top rail assembly to the rack with four 10-32 screws, two screws on each end of the top rail assembly.
For rails with round holes, use two 10-32 screws with washers on each end of the top rail assembly. Tighten the
screws according to specifications under Torque Requirements .
Installing Shipping Brackets (Optional)
Shipping brackets are required when devices are installed with the intent to ship preinstalled in a rack. Use these brackets
as an alternate method from what is explained in Installing the Device in the Rack to secure the device to the rack for
shipping.
Parts in the following table are provided with your rack mount kit for installing these shipping brackets on the device and
the device into a rack.
NOTE
Not all parts may be used with certain installations depending on the device type.
Table 12: Hardware for Optional Chassis Shipping Brackets
Description Quantity
Mounting plates 2 (marked A and B)
L-brackets 2 (marked R and L)
6-32 x 3/8 in. panhead Phillips screw with square cone washer 10
10-32 x .63 in.(1.60 cm) panhead Phillips screw with square cone washer 23
10-32 clip nut for racks that have rails with round holes 6
10-32 retainer nut for racks that have rails with square holes 6
For steps to install these shipping brackets, see the Installing Brocade Chassis Shipping Brackets instructions packaged
with the bracket parts.
Installing the Device in the Rack
DANGER
Use safe lifting practices when moving the product.
1. If a door is installed on your chassis, ensure that it is removed. See the procedures for removing and replacing the
device door in this guide.
2. Use a lift to raise the device to the correct level.
3. If applicable, lock the wheels of the lift.
4. Carefully lift the device and slide it into the rack.
5. Secure the device to the rack with six 10-32 screws with washers. Tighten the screws according to specifications
under Torque Requirements .
53-1004106-15
38