Broadcom ACPL-352J, Справочное руководство

Страница: 9 / 42

Broadcom ACPL-352J-EB1200-RM100
9
ACPL-352J Reference Manual Infineon EconoPIM™ 3 IGBT Module EB1200-352J Evaluation Board
Chapter 3: System Description
This chapter provides the EB1200-352J specifications and functional description, interfaces, and mechanical details.
3.1 Key Specifications
Table 1 lists the absolute maximum ratings of the EB1200-352J. Note that Table 1 contains only key parameters. Constraints
from ACPL-352J data sheet as well as specifications of other key components must be considered when the EB1200-352J
is used.
3.2 Functional Block Diagram
Figure 2 shows the functional block diagram and Figure 3 shows the disposition of the functional blocks of the EB1200-352J
gate evaluation board. In the middle of the system is a power integrated module (yellow), and its DC terminals are connected
to a DC bus capacitor bank (blue). The DC bus can be supplied with an AC power source by using an integrated three-phase
diode rectifier, or externally through the DC bus terminals. If a diode rectifier is used, the negative side of the diode rectifier
(N_REC) and the negative side of the DC bus (–DC_BUS) must be shorted. The DC bus terminals as well as other power
terminals are shown in grey in
Figure 2 . Low-voltage side connectors aimed for signal interface and power supply of digital
side of ACPL-352J drivers are presented in green.
Table 1: Absolute Maximum Ratings
Parameter
Values
Units Note Min. Typ. Max.
V
dc+
to V
dc–
when the DC
bus supplied externally
— 600 800 V Limited by the voltage overshoot during turn-off
transient. DC bus capacitors voltage rating is 900V.
Input rectifier line to line
RMS voltage — 400 480 V N_REC terminal should be shorted with -DC_BUS
terminal, and one of the following conditions should be
satisfied if the board is powered through three-phase
AC lines (L1, L2, L3):

Pre-charge circuit is added externally.

Powering the board through an autotransformer
enables smooth charging of the DC bus.
Brake chopper current — — — A Limited by the power module ratings.
Inverter IGBT peak
current — — — A Limited by the power module ratings.
Continuous RMS current — — — A Limited by the power module ratings and the heatsink
characteristics.
V
CC
input voltage 21.6 24 26.4 V External DC input power supply for the digital circuitry.
PWM input logic level 0 3.3 5 V External PWM inputs for the gate drivers; thresholds
are defined in the ACPL-352J data sheet.
Fault output logic level 0 — 5 V Logic output signal, refer to the ACPL-352J data
sheet.
UVLO output logic level 0 — 5 V Logic output signal, refer to the ACPL-352J data
sheet.
GFAULT output logic level 0 — 5 V Logic output signal, refer to the ACPL-352J data
sheet.