e-mail:
voice:
360.854.9559
fax:
866.783.1742
26
AES Switcher Sentinel
®
2+1 Installation and Operation Manual
WEB SETUP
“Email/Network Setup” Web Page – SNMP Manager Settings
SNMP Enable:
Enables or disables SNMP functionality, enabled by
default.
SNMP Enable Traps:
When enabled, SNMP trap messages will be sent. When
disabled, no trap messages will be sent to the manager IP.
SNMP Trap IP Address: This is the IP address of the SNMP manager. The system
will send traps to UDP port 162 at this IP address.
SNMP Read Community: This is the community name used for Read-Only access.
SNMP Write Community: This is the community name used for Read-Write access.
NOTE:
A cold-start trap will be sent when the unit boots up if the SNMP Enable
Traps are enabled and trap messages will be sent when a device enters or exits an
alarm condition, depending on whether or not alarms are enabled.
“Email/Network Setup” Web Page – NTP Settings
NTP Enabled:
Enable for NTP network time sync. Default: Enabled
NTP (Time) Server Address:
Enter the NTP address here. Default: pool.ntp.org
NTP Port:
Port used to connect to NTP server. Default: 123
NTP Update Interval (Min): Interval between time updates.
Default: 30
WEBSITE:
Visit our web site for
product updates and
additional information.
