Brixton BQ-6310, Руководство пользователя

Страница: 22 / 48

GAS CONNECTION
Check whether your barbecue is installed correctly. This manual provides detailed mounting
instructions which
include specific mounting procedures. Strictly observe these instructions to ensure
correct and safe installation of the barbecue.
For correct functioning of the barbecue, it is important to place the barbecue on an even surface.
This barbecue is set up to be used with butane or propane gas bottles from 5kg till 15kg, with
appropiate gas pressure regulator.
For replacement of the gas pressure regulator and hose please see below table for correct
specifications:
Category Gas and pressure Countries Injector
I3+ (28-30/37) Butane 28mbar /
Propane 37mbar GB. IE, BE. CH. ES. FR.
GR. IT & PT Burner: 0,97mm
I3 B/P (30) Butane / Propane
30mbar DK, FI, GR, LU, NL, NO
& SE Burner: 0,97mm
The gas hose must not be longer than 1.5 mtr. Only use approved connections. The gas hose
needs to be adjusted if national circumstances require. The gas hose needs to be fitted in such
a way that it can not be twisted.
For your safety:
Make sure all black plastic grommets of the pressure regulator are in place, and that the hose is not
making contact with the heat protection of the BBQ itself.
Connect the pressure regulator to your gas cylinder.
VERY IMPORTANT:

The temperature of the regulator may not exceed 60°C (140F).
The regulator must be equipped with a safety valve or pressure limiter.

The opening of the regulator must fit the connection of the gas tap of the cylinder.

Check whether the gas tap of the tank is completely closed (turn clockwise until the knob stops).

Check whether the gas tap of the gas cylinder is provided with suitable outer threads.

Make sure that all burner knobs are set to position “off”.

Remove the protective cover from the gas tap of the gas cylinder. Always use the protective cover
supplied with the gas tap.

Inspect the connection between the gas tap and the pressure regulator. Look for damage and dirt.
Remove any debris. Check the hose for any damage. Never try using damaged or blocked
equipment.
Contact your local L.P. gas supplier for repairs.

When connecting the pressure regulator to the gas tap, manually turn the nut clockwise until it
doesn’tgo any further. Do not use a wrench to tighten the nut. Using a wrench can damage the
joints, which
can be dangerous (as illustrated in the picture below).

Turn the gas tap of the cylinder fully open (counter-clockwise). Use a solution of water and soap to
check for any leakage before trying to ignite the grill. If you encounter a leak, you must shut off the
gas
tap and only use the grill after the leak is repaired by a local L.P. gas supplier.