Brivo Allegion AD400, Руководство по настройке, Страница: 1 / 11

Allegion AD400 Configuration Guide
for Brivo Onair
Allegion AD400 wireless locks communicate with a Brivo access control system via a Panel Interface Module (PIM).
The Allegion AD400 locks are each linked with the Panel Interface Module via a Hand Held Device (HHD) using the
Schlage Utility Software (SUS) and may be added as devices to the Brivo Onair account.
Introduction
I
Brivo Onair - Allegion Topology .................................................... 2
Required Components ................................................................... 2
Preparation
II Mandatory Planning Before You Begin ........................................ 3
Wiring ACS6000-E/ACS300-E to Allegion PIM .............................. 3
Configuration
III
Overview of Configuration Process .............................................. 4
Couple a PIM400-485 unit to the HHD ......................................... 4
Update the PIM400-485 firmware ................................................ 4
Configure the PIM400-485 unit ..................................................... 4
Couple an AD400 Wireless Lock to the HHD ............................... 5
Update the AD400 Wireless Lock firmware ................................. 6
Configure an AD400 Wireless Lock ............................................... 6
Linking an AD400 Wiress Lock and a PIM400-485 Unit .............. 6
Associating with Onair
IV
Creating an Allegion Panel Interface Module .............................. 7
Editing an Allegion PIM ................................................................... 9
Deleting an Allegion PIM ................................................................ 9
Creating an Allegion AD400 Lock Device ..................................... 9
Editing an Allegion AD400 Lock Device ...................................... 11
Deleting an Allegion AD400 Lock Device .................................... 11