Britton Dolphin, Инструкция пользователя

Страница: 3 / 23

1a . Battery installation
Use a small screwdriver to open the battery compartment door
on the vibration unit. Insert the battery as indicated inside the
battery door and replace the screw.
1b. Assemble the vibration unit to the foot rest wire
Lay the foot rest frame (part 2) onto a flat surface as shown.
Slide the vibration unit onto the wire until it clicks.
2. Base assembly
Place the left and right base frames and base connector on a flat
surface as shown. Make sure the edge of the rubber grip slide
base connector into left base frame.
3. Foot rest frame
Slide the looped ends on the foot rest over the left and right base.
4a and 4b. Split back frame
4a: slide the left and right sides of back frame into each other,
being sure the the silver locking button is securely locked into
place.
4b: slide connected back frame onto the left and right base frames
and press securely into place. Be sure that silver buttons on each
side are securely locked into place.
5. Seat pad
Slide the seat pad over the back frame. Raise the footrest frame
and slide the seat pad over it. The front of the vibration unit
should be visible through the seat pad opening.
6a and 6b.
6a. Slide the looped ends of the footrest over the curved part of
the frame until it rests securely on the „wings” as shown in photo.
6b. After seat pad has been positioned into place, push gently on
the footrest clip until you hear a „click” as shown in photo 6b.
Repeat on other side.
2
ASSEMBLING