29004091
Your Real Time Electricity Monitor is Now Up
and Running
Setting Your Clock
To set the clock please follow these steps.
•
To set the clock, hold the Centre Button on the Display until the LED fl ashes.
When you let go the screen will clear and the clock hours will fl ash.
•
Use the Up and Down buttons to set the hour - the Monitor has a 24 hour clock.
Once the correct hour is selected press the Centre button to accept.
•
The minutes will now fl ash. Use the Up and Down buttons to set the minutes.
•
Push the Centre button, and the display will return to normal operation.
Setting Your Electricity Price
Your monitor has been set with an average unit rate of 13.96 p/kWh.
If you wish to change this follow these steps.
•
Press the Up button for three seconds until the LED fl ashes and release.
•
Push the Up or Down button to change between Euros and Pounds and press
the Centre button to confi rm.
•
The unit price will start fl ashing. Press the Up or Down button to adjust the price
of the electricity fi rst three digits - press the Centre button to confi rm.
•
Repeat this process to set the last digits - press the Centre button to confi rm.
•
The display will return to normal operation. Your new electricity price has now
been set.
The unit has been set up for single rate meters. If you have a two rate meter
such as Economy 7 follow these steps.
•
Press and hold the Up and Down buttons together for three seconds until
the LED fl ashes and release
•
Use the Up and Down buttons to set your low rate tariff. Press the Centre button
to confi rm.
•
The clock will start to fl ash. Use the Up and Down buttons to set the time
the low rate starts. Press the Centre button to confi rm.
•
Repeat these steps to set the time for your second rate.
•
The display will return to normal operation.
Frequently Asked Questions
Why is my screen showing a series of dashes?
The display needs pairing to the Transmitter – refer to ‘Setting Up
’
.
Why is my screen showing ‘0 watts’?
The display is ready to use – refer to ‘Setting Up
’
to continue with installation.
My display has a corrupt/no display?
Check the monitor is properly connected to the power supply.
If your monitor still does not work properly see the ‘Contact Us’ section.
My readings don’t seem to be consistent with my consumption?
There is a very small chance your Monitor is receiving a signal from another
transmitter. Repeat the pairing of your transmitter again.
Why does the data on the display never change?
The unit may not have been set up correctly. You should start the set up process again.
Why does the temperature reading seem too high?
This Display may be too close to a heat source; try moving it to a
different location.
Why does the cost seem to be incorrect?
Follow the process in the ‘Setting Your Electricity Price’ section to set your
preferred price.
For more information on setting up your Real Time Electricity Monitor, there is a
video tutorial available at
www.currentcost.com/britishgas
If you have any other problems you cannot fi x, do not attempt to repair the
equipment, disconnect the Sensor and Monitor and refer to the ‘Contact Us’ section.
Additional Accessories
There are additional accessories available for your Real Time Electricity Monitor.
This includes additional monitors, additional sensors for use with 3-phase meters,
plug socket sensors to monitor individual appliances in the home, and cables to
download your consumption history to a PC.
Contact Us
If you have any questions please contact us by email at
energyef
fi
If you have a faulty monitor please return to Freepost NWW1657, PO Box 7,
Manchester M19 2PB including your full name and address.
4
5
Your energy experts
Real Time
Electricity Monitor
Instruction Manual
Down
Down
p
DAY
ELECTRIC
C
