Supplied By www.heating spares.co Tel. 0161 620 6677
B BOILER CONTROLS
LEGEND
A.
Boiler thermostat knob.
B.
Main burner 'On' neon.
C.
Control panel door.
Repeat the procedure 1 - 5 detailed in 'To light the boiler'.
Frost protection
If no frost protection is provided and frost is likely during a short
absence from home, leave the heating controls (if fitted) at a
reduced temperature setting.
For longer periods, the entire system should be drained -
including the domestic water supply.
If the system includes a frost thermostat then, during cold
weather, the boiler should be turned OFF at the time switch (if
fitted) ONLY. The mains supply should be left switched ON, with
the boiler thermostat left in the normal running position.
Boiler Overheat Thermostat
The boiler is fitted with a safety 'cutout' thermostat: this
thermostat will shut down the boiler in the event of overheating.
Should this occur turn off the boiler and consult
a
CORGI
registered installer .
Loss of system water pressure
(Boilers fitted with sealed system unit)
If the red arrow on the system pressure gauge is set above zero
and the system pressure is seen to fall below this value over a
period of time then a water leak is indicated. In this event
a
CORGI
registered installer should be consulted.
DO NOT FIRE THE BOILER IF THE PRESSURE HAS
REDUCED TO ZERO FROM THE ORIGINAL SETTING
Escape of gas
Should a gas leak or fault be suspected, contact your gas supplier
without delay.
Do NOT search for gas leaks with a naked flame.
Cleaning
For normal cleaning simply dust with a dry cloth.
To remove stubborn marks and stains, wipe with a damp cloth and
finish off with a dry cloth.
Do NOT use abrasive cleaning materials.
Maintenance
The appliance should be serviced at least once a year by
a
CORGI
registered installer .
Note.
The appliance model is given on the data plate, located on
the front of the boiler base plate, behind the grille assembly.
THIS SYMBOL IS YOUR
ASSURANCE OF QUALITY
These appliances are designed for use with Natural
Gas only. They have been tested and conform with
the provisions of BS. 6332 and BS. 5258.
CERTIFIED PRODUCT
Manufactured under a BS EN ISO
9001:1994 Quality System
accepted by BSI
May 2001
UIN 155 180 A03
The code of practice for the installation,
commissioning & servicing of central heating systems
British Gas Services
Limited
is a member of the Benchmark
initiative and fully supports the aims of the programme.
Benchmark has been introduced to improve the standards of
installation and commissioning of central heating systems in
the UK and to encourage the regular servicing of all central
heating systems to ensure safety and efficiency.
British Gas
pursues a policy of
continuing improvement in the
design and performance of its
products. The right is therefore
reserved to vary specification without
notice.
British Gas Services Limited.
Registered in England No. 3141243. Registered Office:
Charter Court 50 Windsor Road, Slough, Berkshire SL1 2HA. British Gas Services Ltd.
has made every effort to ensure that the information contained in this leaflet is accurate.
However, not all the information is within the control of British Gas Services Ltd., and it
may have changed since publication. British Gas Services Ltd. does not accept any
liability for changes which occur after publication. No guarantee takes away any rights
you may have at law. Calls to this number may be monitored to maintain a high level of
service and for training purposes.
Priority Helpline 08459 500 400
This boiler is exclusively manufactured for British Gas by Ideal Boilers Ltd.
