Briteq BT-POWERJET, Руководство по эксплуатации

Страница: 6 / 10

ENGLISH OPERATION MANUAL
BRITEQ
®
4/7 BT-POWERJET
•
Once the correct mode is shown on the display, press the ENTER button to confirm.
•
You can repeat these actions to set the color for the other LED group
FLUID SENSOR
Used to switch the fluid sensor ON or OFF. We strongly advise you to have the fluid sensor ON to
avoid to use the unit when the fog fluid container is empty (what can damage the unit)
•
Press the MENU button until FLUIR SENSOR is shown on the display.
•
Use the DOWN and UP buttons to change to select ON (sensor ON) or OFF (sensor OFF/so detection).
•
Once the correct mode is shown on the display, press the ENTER button to confirm.
HALF POWER MODE
If for any reason, you don
’t need to use the full potential of the unit, HALF POWER MODE can be
switched on.
When OFF, the heater will work at FULL POWER (3200W) and reheating is fast.
When ON, the heater will work at HALF POWER (1600W) but reheating will also be slower.
•
Press the MENU button until HALF POWER MODE is shown on the display.
•
Use the DOWN and UP buttons to switch the half power mode ON or OFF.
•
Once the correct mode is shown on the display, press the ENTER button to confirm.
GENERAL OPERATING INSTRUCTIONS
WARNING: the unit has a HOT and powerful output ! Keep a minimum distance of 1m .
•
Put the fogger on a flat and very stable surface. Make sure that nobody can put their hands just in front of
the output. The fog is very hot and can cause serious burnings!!!
•
Make sure the fog liquid tank is not empty. Always use good quality fog liquid to fill up the tank. Close the
tank immediately to prevent dirt to enter the reservoir!
•
Make sure to plug the fogger in a mains wall socket with earth connection
•
Switch the fogger on and wait for about 3 to 4 minutes. (warm up time)
•
WARNING: NEVER use the machine with an empty reservoir. This can damage the pump !
DMX-OPERATION:
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Electrical installation:
•
The DMX-protocol is a widely used high speed signal to control intelligent light and other equipment. You
need to “daisy chain” your DMX controller and all the connected units with a good quality balanced
cable.
•
Both XLR-3pin and XLR-5pin connectors are used, however XLR-3pin is more popular because these
cables are compatible with balanced audio cables.
Pin layout XLR-3pin:
Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+)
Pin layout XLR-5pin:
Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+) ~ Pins4+5 not used.
•
To prevent strange behavior of the light effects, due to interferences, you must use a
90Ω to 120Ω terminator at the end of the chain. Never use Y-splitter cables, this
simply won’t work!
•
Make sure that all units are connected to the mains.
•
Each unit in the chain needs to have its proper starting address so it knows which
commands from the controller it has to decode. In the next section you will learn how to set the DMX
addresses.