ENGLISH
OPERATION MANUAL
BRITEQ
®
6/11
BT-NONABEAM
FAN
Used to set the working mode of the cooling system.
•
Use the
▼/▲ buttons to browse the menu until the required function shows up.
•
Select the function with the ENTER button.
•
Use
▼/▲ buttons to select the desired mode:
•
AUTO
The fans are temperature controlled.
•
FULL
The fans are running at full speed to assure maximum cooling.
•
Once the correct option shows on the display, press the ENTER button to save it.
Remark: this option can be overruled using the DMX-control channel.
PIX + RGB °C
Used to show the temperature of the LEDs.
•
Use the
▼/▲ buttons to browse the menu until the temperature display is showing.
FIRMWARE
Used to show the current version of the firmware.
•
Use the
▼/▲ buttons to browse the menu until the FIRMWARE is showing on the display.
Note:
The firmware of this unit can be upgraded using our special “Firmware Updater 2” (separately
available from Briteq). More information about this can be found in the user manual of the firmware updater
or our website: https://briteq-lighting.com/firmware-updater-2
OVERHEAD RIGGING
•
Important:
The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
•
Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
•
Locate the fixture in a well ventilated
spot, far away from any flammable
materials and/or liquids. The fixture
must be fixed
at least 50cm
from
surrounding walls.
•
The device should be installed out of
reach of people and outside areas
where persons may walk by or be
seated.
•
Before rigging make sure that the
installation area can hold a minimum
poin
t load of 10times the device’s
weight.
•
Always use a certified safety cable that
can hold 12times the weight of the
device when installing the unit. This
secondary safety attachment should be
installed in a way that no part of the installation can drop more than 20cm if the main attachment fails.
•
The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
•
Don’t cover any ventilation openings as this may result in overheating.
•
The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
