ENGLISH
USER MANUAL
Briteq
®
10/13
BT-AKKULITE IP
To disconnect an individual receiver from a DMX universe / transmitter:
•
Press the [ID] button (24) of the receiver until the status LED (16) becomes WHITE (RGB lit).
•
This receiver is now disconnected from the transmitter (DMX universe).
OPERATING INSTRUCTIONS
A. Standalone 1unit:
•
Select one of the automatic modes or select a fixed color
•
Select the static or sound control mode
•
Refer to chapter [SETUP MENU] to learn how to make the previous settings.
B. Two or more units in master/slave setup:
•
Connect 2 to maximum 16 units together. Refer to the chapter “electrical installation” to learn how to
do this.
•
Set the slave mode for each projector: the first one must be set on in DMX mode or in a show mode
(for example :
[FAdE]
)
•
Connect all units to the mains. The units will start working automatically and show the internal chase
programs.
Remark: You can connect a JB Systems LEDCON-02 Mk2 or LEDCON XL remote controller to the
master unit if you want to have more control over the master/slave operation. All projectors must be in
LEDc mode!
C. Connect an optional JB Systems LEDCON-02 Mk2 or LEDCON-XL controller for more control:
The JB Systems LEDCON-02 Mk2 or LEDCON-XL controller can only be used in standalone or
master/slave mode. Connect the controller to the DMX-input of the first unit (master). Make sure that the
BT-AKKULITE IP projectors are all set to
channel mode [LEDc]. Now you can control all the connected
units in 4 or 8channel mode. Refer to the user manual of the JB Systems LEDCON-02 Mk2 or LEDCON
XL controller for more information.
D. Controlled by IR remote-controller:
Switch on the projector (5). Push button [ON] on the IR remote controller. [Jr--]
will appear on the display. You are now ready to use the IR remote controller.
When you turn the projector off with the IR remote controller, [Jr0F] will be
shown on the display.
Before you can start using the projector with another controller you have to
push one of the buttons under the display ([MENU]-[
▲]-[▼]-[ENTER]). The
projector will now be disconnected from the IR remote controller.
You can also use the IR remote controller with several projectors in Master-
slave mode. Select the desired color, fade on the Master. The slaves will follow
the instructions from the Master projector.
E. Controlled by universal DMX-controller:
•
Connect all units together. Refer to the chapter “Electrical installation for two
or more units in DMX-
mode” to learn how to do this (don’t forget to address
all units properly!)
•
Turn on the DMX controller.
Since each unit has its own DMX-address, you can control them individually. Remember that each unit
uses 4 to 10 DMX-channels as shown in the DMX charts below:
