A.
Turn walker upside down on top of the carton. Insert
the end of the wheel posts all the way into the
holes at the corner of the walker base using moderate
force.
NOTE: Clean grip pads regularly, using warm water
with a household soap or mild detergent to maintain
stopping performance.
A.
Turn walker right side up.
B.
Position one hand underneath the top edge of the tray,
and the other hand on the top of the outer base
frame.
C.
There are three height adjusting positions. Lift the tray
slowly while holding down the base until you hear the
tray lock into the first/lowest position. (If raised past
the first/lowest position then see step 7D/E to lower it.)
A.
The seat needs to be attached to the frame. There are
six attachment points at the rear and four at the front.
B.
Position the seat into the upper tray cavity.
C.
Begin to attach the seat from the rear by locating the
plastic pins over the engagement holes. One at a
time, slide each pin into the holes and lock into
position. Make sure all six pins are engaged. Pull up on
the seat to confirm. Repeat steps if not locked into
upper tray.
D.
Attach the seat to the front section. Locate the plastic
pins into the holes and push down until locked.
Pull down by the fabric to lock the pins if a little tight.
Make sure all four plastic pins are engaged.
NOTE: You will need 2 x AA batteries for the lights and
sounds. Batteries are not included.
A.
Turn over the activity tray, undo the battery cover
screw and remove the cover. Fit 2 x AA batteries in
the direction shown. (Check that the batteries are
fitted correctly by pushing one of the coloured
buttons.) Replace cover and secure with screw.
A.
A.
B.
C.
A.
A.
B.
C.
D.
C.
ZoomWalkerInstructions.indd 4
3/9/08 3:20:39 PM
