Starriser Comfy
TM
: Adjustments
IMPORTANT:
This section applies only to the Starriser Comfy. If
you are using a Starriser, refer to page 12.
The purpose of the Starriser Comfy belt-adjusting booster with
backrest is to adapt the adult vehicle safety belt to the body size of
the child. It is important to adjust the width of the booster base
correctly and to use the belt guide to properly align the safety belt.
Adjusting the Base
The armrests of the Starriser Comfy must
be snug against the hips of the child to
properly align the lap belt across the
child’s hips.
1
Turn the width adjustment knob
counter-clockwise to loosen. (Fig. A)
2
Pull sides of booster apart. (Fig. B)
3
Adjust width as shown in Figure B.
4
Turn the width adjustment knob
clockwise to tighten. (Fig. A)
• Make sure that the cover fasteners are
properly adjusted to the new position.
NOTE:
As your child grows, further
width adjustments will be necessary.
Removing the Backrest
1
Pull connector release button (Fig.
C-1) toward the front of the seat,
while pulling the wedges (Fig. E) up
and away from the seat to remove.
2
Press both connector release buttons
(Fig. C-1), then pull backrest away
from the base to remove.
WARNING:
Leave the wedges attached
to the backrest. If not attached, the wedges
could be lost or pose a choking hazard.
IMPORTANT:
Do not use the backrest
alone. The backrest must be correctly
installed on the Starriser base before use.
Attaching the Backrest
1
Locate the slots located at the rear of
the base. (Fig. D-2)
2
Insert the connectors (Fig. D-3)
located at the bottom of the back-
rest into the slots on the base.
3
Pull connector release button
(Fig. C-1) toward the front of
the seat, while inserting the
wedges into the slots behind
the connectors. (Fig. E)
Starriser Comfy
TM
: Adjustments
8
9
B
A
D
C
E
P2027_R10.qxd 11/3/2004 4:38 PM Page 10
