36
37
Cover Removal
Care and Maintenance
WARNING!
Do not take apart or attempt to take apart
the harness. Never remove the buckle tongues from the
harness. They cannot be reattached after removal. If reassembled
incorrectly, the child seat may not perform as intended.
Remove toddler pillow by unhooking each
attachment clip.
Remove infant body pillow.
Loosen harness by pressing the harness
adjuster button while pulling shoulder straps
forward as far as possible.
Unhook shoulder straps from yoke on rear
of child seat (Fig. A).
Pull upper harness straps through the shell
and cover to front of child seat.
Gently remove the upper portion of the
cover. Be careful not to damage the energy-
absorbing foam.
Remove buckle and belly pad by turning the
metal buckle strap retainer of the buckle on the underside of
the child seat so the short side will slide through the child seat
shell (Fig. B).
Push the retainer through slots in the shell and cover, to the top
of the child seat.
Pull lower harness straps, buckle tongues, HUGS™ pads, and
chest clip through lower slots in cover.
Remove entire cover from child seat.
For additional demonstration please visit www.BritaxUsa.com.
1
2
3
4
5
6
7
8
9
10
B
Refitting the Cover
To refit the cover, reverse the previous directions. Make sure the
shoulder straps are properly threaded through the chest clips and
the harness is not twisted.
Cleaning the Cover and Pillows
HAND WASH using cold water and mild soap.
LINE or LIE-FLAT DRY to prevent cover from shrinking.
DO NOT
bleach, machine wash, machine dry or iron.
Cleaning the Shell
SPONGE CLEAN using warm water and mild soap.
TOWEL DRY
DO NOT
use solvents, abrasive cleaners or disassemble the
harness.
Cleaning the Harness
SPONGE CLEAN using warm water and mild soap.
TOWEL DRY
DO NOT
bleach, machine wash, machine dry or disassemble
the harness.
•
•
•
•
•
•
•
•
•
Care and Maintenance
A
P276000_R2.indd 36-37
1/2/2008 10:16:21 AM
