Britax Car Seat, Руководство пользователя

Страница: 19 / 20

36 37
Cover Removal Cleaning the Cover
HAND WASH using cold water and mild soap. •
LINE or LIE-FLAT DRY to prevent the cover from shrinking. •
DO NOT • bleach, machine wash, machine dry or iron.
Cleaning the Shell
SPONGE CLEAN using warm water and mild soap. •
TOWEL DRY •
DO NOT • use solvents, abrasive cleaners or disassemble the harness.
Cleaning the Harness
SPONGE CLEAN using warm water and mild soap. •
TOWEL DRY •
DO NOT • bleach, iron, machine wash, machine dry or disassemble
the harness.
Cleaning the Harness Adjuster
Periodically check the adjuster area to be sure it is clean and free of
food, drink or other debris. If debris is present, it must be removed to
prevent interference with the adjuster mechanism.
BRUSH AWAY LOOSE DEBRIS using a soft-bristled brush. •
SPONGE CLEAN using warm water and a mild soap. •
TOWEL DRY •
DO NOT • use solvents, abrasive cleaners or disassemble the harness.
WARNING! Do not take apart the harness. Never remove
the buckle tongues from the harness. They cannot be reattached
after removal. If reassembled incorrectly, the child seat may not
perform as intended.
Loosen the harness by lifting the harness 1
adjuster lever while pulling the shoulder straps
forward as far as possible.
Unhook the shoulder straps from the harness
2
yoke on the rear of the child seat (Fig. A).
Pull the upper harness straps through the shell
3
and cover to the front of the child seat.
Remove the buckle and belly pad. See page
4
38.
Gently remove the upper portion of the cover. Be careful not to
5
damage the energy-absorbing foam.
Pull the lower harness straps, buckle tongues, HUGS™ chest pads,
6
and chest clip through the lower slots in cover.
Remove the entire cover from the child seat.
7
Refitting the Cover
To refit the cover, reverse the above directions. Make sure that the
shoulder straps are not twisted, and are threaded properly through the
chest clips, cover, foam, and shell.
A
Care and Maintenance Care and Maintenance