Installation and Mounting
Magnetic Mounting:
The magnetic based beacon provides a secure, temporary installation. The beacon
should be placed in the centre of the roof where the least amount of curvature
occurs. Check the magnet for debris before installation. Any foreign matter can
reduce holding power and scratch the vehicle. The roof surface should be dry
and have a dull, not glossy finish. A glossy, highly waxed surface will reduce the
magnet’s holding power. When placed, the beacon should adhere firmly. The user
should not attempt to drive with the beacon in place should the unit slide or move
easily.
Permanent Mounting:
The permanent mount beacon provides a secure, permanent installation. Wire
routing should be taken into consideration when choosing a mounting location.
Wiring Instructions
Consideration has to be taken to make sure the wire gauge is sufficient to drive the
product. AWG18 or above is recommended.
Magnetic base version BFR1004 only has Red and Black wire.
COLOR . . . . .FUNCTION . . . . . . . . . CONNECT TO
Red . . . . . . . .Power. . . . . . . . . . . . . .
+VDC
Black . . . . . . .Ground. . . . . . . . . . . . . Chassis Ground
Violet. . . . . . .Dimming . . . . . . . . . . . Ground to dim or open for full output
Operation:
Flash speed selection
1. 180rpm: Bank A selection jumper is on the left location
2. 120rpm: Bank A selection jumper is on the right location
Rotation direction selection
1. Anti-clockwise: Bank B selection jumper is on the left location
2. Clockwise: Bank B selection jumper is on the right location
Dimming (not available for BFR1004 magnetic version)
1. Default 100% light output.
2. Connect violet wire to ground: diming to 30% light intensity.
Maintenance:
The beacons are completely sealed units designed to be maintenance free.
There are no repairable parts inside.
Issue date
10 February 2016
Bank B
selection jumper
Bank A
selection jumper
WARNING!
As with any magnetically-mounted warning device, its use on the exterior
of a moving vehicle is at the sole discretion and responsibility of the user.
This magnetic mount product provides a secure, temporary installation in
most circumstances and is recommended for stationary use only.
Warranty
Britax Automotive Equipment (BAE) guarantees this product against defects
of materials and workmanship for a period of 3 years from the date of
purchase provided the product is used for its proper purpose, and is installed
in accordance to this instruction sheet. BAE will at its own option and cost
make good, or replace this product with the same or similar product and return
it to you, or provide a credit, if the product proves to be defective within the
limits set out above provided that no repairs, alterations, or modifications to
the product have been undertaken or attempted by anyone, other than BAE or
their authorised agents. Should you wish to make a claim under this guarantee,
the product and proof of purchase must be returned pre-paid by you to the
place of purchase. This guarantee is in addition to and does not take away
from any other rights and remedies you may have under any relevant law.
Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable loss or damage. You
are also entitled to have the goods repaired or replaced if the goods fail to be
of acceptable quality and the failure does not amount to a major failure. Please
retain your proof of purchase for all warranty claims.
For all warranty enquiries:
Britax Automotive Equipment Pty Ltd
4 Garret Street Brendale 4500 Australia
PO Box 5940 Brendale DC Qld 4500 Australia
T +61 7 3293 7900 | F +61 7 3293 7999
