7
RF-103 installation instructions
Version 1.0E
• Filter should be replaced every 5 years
(or sooner if pressure drop occurs).
• Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection
before or after the system.
•
Check filter every six months for leaks.
• Filter life and/or capacity is dependent upon
filter system, water quality and amount of
water filtered.
Filter Replacement
(every 5 years)
Performance
Data and
Maintenance
Brita
®
Filter RF-103
The Brita® Inline Icemaker filter used with this filter
system has a limited service life. Changes in taste,
odor, and/or flow of the water being filtered indicate
that the filter should be replaced.
Expected life of this filter is 5 years. Filter may need
to be changed sooner due to sediment in your water
source. For product information and assistance call
828-449-1040.
RE
PLA
CE EVERY
FIVE YEAR
S
Need Help? 1-866-709-2086
Be sure to turn off the cold water supply until leak issue is resolved.
Installation Requirements
Operating Pressure: 30-100 PSI (207-690 kPa)
Temperature Range: 40-100°F (4.4-37.7° C)
Flow Rate: 0.5 GPM ( 1.9 lpm)
•
Make sure the flow direction is
correct.
• Disconnect adapter fitting by
pushing the collet inward and
pulling the fitting out.
• Remove the adapter fitting from the
filter and discard. (See diagram).
• Cut the end of the tubing squarely.
Check the end of the tube to make
sure it is smooth with no ridges or
nicks. If needed cut the tubing again.
• Push tubing through the collet and
all the way into fitting. The length
of the tubing should extend 11/16”
into the fitting.
• Check for leaks.
Option
Optional Install for
¼” Plastic or
Copper tubing
do not bend or crimp
cut squarely on both ends
do not cut at an angle
wet ends of tubing before inserting
Содержание RF-103
Страница 8: ...8...
