Brita Redi-Twist USS-335, Руководство по установке

Страница: 20 / 56

20
You can also run the drain tubing to an existing drain in the house. A floor drain, laundry
tub, standpipe, sump, etc. are suitable drain points. This type of drain is preferred over
the drain connector. Check your local codes. Longer lengths of tubing (see parts list in
manual) may be needed.
Always be sure to provide an air gap between the end of the hose and the drain point.
This will prevent water from backing up into the system. Air gaps are required code in
most areas.
materials and tools needed
WARNING
Install a Remote Drain Point and Air Gap (Remote Location)
Install System/Drain in
Remote Location
• Remove 1/4" Red Plastic Tubing from RO Faucet Body by pulling gently.
• Determine if this length is long enough to reach drain point. If so, insert Restrictor
in end of tubing and then insert this end of tubing into drain port on RO Membrane
Filter.
• If not, replace 1/4" Red Plastic Tubing with an adequate length of tubing to reach
drain point. Then insert Restrictor in end of tubing and then insert this end of tubing
into drain port on RO Membrane Filter. Refer to Step 6 in manual on how to
disconnect and connect tubing.
• Run tubing to drain point and secure at end with a bracket (purchased locally).
Provide a 1-1/2" air gap between end of tube and drain.
• Remove 3/8" Red Plastic Tubing from RO Faucet Body and discard.
• Faucet will not have 1/4" or 3/8" tubing attached to airgap barbs in the RO Faucet
Body for remote installation.
To install a remote drain point, complete the following steps:
HOT
COLD
Packaged Items
Shown in White
Storage Tank
1/4” line to Tank
1/4” line to Faucet
3/8” line to Drain
1/4” line to Filter
Kitchen
Faucet
Adapter
1/4" white tubing t ter
1/4" red tubing to
membrane drain
3/8" red tubing
to drain
3/8" white tubing to faucet
3/8" white tubing
to tank
Drain
Connector