4
1
Pack Contents
Installation Instructions
& User Guide
1.0
5.0
Pressure
BAR
0.2
4.0
2.0 3.0
Pressure
BAR
1.0
5.0
0.2
4.0
2.0
3.0
Specifications
Maximum Static Pressure: 10.0 bar
Inlet Water Temperature
Inlet Connections
Min: 0.2 bar
Max: 5.0 bar
Dynamic Water Pressure
Tools You’ll Need
Prior to Installation
Phillips Screwdriver Adjustable Spanner
Hexagonal Keys
Installation
Please leave these instructions
with the end user
Product code: VAC BAS C MT (D4)
All products manufactured and supplied by Bristan are safe
provided they are installed, used correctly and receive regular
maintenance in accordance with these instructions.
This product has been tested to the Water Regulations Advisory
Scheme (WRAS) and satisfies the requirements of the Water
Supply (Water Fittings) Regulations 1999 and current bylaws.
For full Installation Requirements & Notes (IRN)
please visit
wras.co.uk/directory.
We recommend isolation valves to be fitted to the inlet water
supplies to ensure ease of future maintenance.
Before installing these taps the water supply must be thoroughly
flushed in order to remove any swarf, solder etc.
This product must not be modified in any way as this will
invalidate the guarantee.
2
Fit the mixer body to
the basin using the
‘C’ plate fixing kit.
Place the washer
over the hole in the
basin and feed the
mixer body and tails
through.
Place the washer and waste body plate
onto the horizontal arm. Screw the waste
body plate onto the lower waste body.
Push the vertical
rod through the
back of the basin
tap.
Connect the rods
using the pop up
connector. Tighten
screws to secure.
Fit the pop up waste,
with the flat washer
below and the shaped
washer above the basin.
3
M12 x 15mm
Copper Tails
5
6
60
°
C
65
°
C
Max
80
°
C
5
°
C
25
°
C
Cold Water Supply
Min: 5°C Max: 25°C
Hot Water Supply
60-65
°
C
recommended
80
°
C
Maximum
To replace any spare parts
for your tap, why not
scan the QR Code or
visit
www.bristan.com
and search for your product.
Spare Parts
x1
IMPORTANT
Turn on w
ater
supply f
or a few
minutes and check
all joints and
connections f
or
any leak
s.
REMEMBER
Hot on the
left, cold on
the right!
TIP
Prefit mix
er
to the basin
before
fitting.
Once secured to
the basin, connect
the hot and cold
water supplies to
the threaded tails.
x2
x1
x1
x1
x1
1x
