Bristan recommend E-
cloth for cleaning all of
our bathroom & kitchen
products. Using just
General Cleaning
General Cleaning
General Cleaning
General Cleaning
Your fitting has a high quality finish and
should be treated with care to preserve the
visible surfaces. All finishes will wear if not
cleaned correctly. The only safe way to clean
your product is to wipe with a soft damp
cloth. Stains can be removed using washing
up liquid. All bathroom cleaning products
(powders and liquids) will damage the
surface of your fitting, even the non-scratch
cleaners.
Note:
Note:
Note:
Note: Never use abrasive detergents or
disinfectants or those containing alcohol,
hydrochloric acid or phosphoric acid.
Maintenance
Maintenance
Maintenance
Maintenance
We advise that your fitting is regulary
serviced in hard water areas to maintain
optimum performance.
If the fitting begins to leak the floowing
should be carried out;
Isolate both hot and cold water supplies to
the tap / mixer by either:
•
Turning water supply off at the mains
stopcock or
•
Turning off the isolation valves to the
kitchen mixer
1. Prise out the cap and loosen the grub
screw.
2. Remove the handle by pulling it from the
Maintenance
Maintenance
Maintenance
Maintenance
products. Using just
water, E-cloth gives a smear
free, deep clean by breaking up and
holding dirt, which normal cloths leave
behind. Order through your Bristan
stockist (order code: ECLOTH).
Cleaning the Showerhead
Cleaning the Showerhead
Cleaning the Showerhead
Cleaning the Showerhead
Your Bristan showerhead has rub-clean
nozzles for easy cleaning. Simply rub your
fingers across the rubber spray jets
regularly and before you turn the shower
on to remove any scale or debris.
The hardness of the water in your area will
determine how often you should clean your
showerhead. Build up of scale in
particularly hard water areas combined
with constant use means you may need to
clean your showerhead once a week.
To ensure continued performance the
showerhead needs to be regularly
descaled.
2. Remove the handle by pulling it from the
valve / cartridge.
3. Remove the valve by unscrewing it from
the body using a suitable spanner.
If cartridge remove shroud and unscrew
cartridge retaining nut using a suitable
spanner.
4. Clean valve / cartridge and seating. If
necessary replace the valve / cartridge.
5. Replace the valve and tighten fully using
a suitable spanner.
If cartridge fit back into the body, the
cartridge has locating pins on the
bottom which align with locating holes in
the body. Tighten the cartridge retaining
nut and screw the shroud back on.
6. Replace the handle, tighten the grub
screw and push the cap back on.
13
www.divapor.com
