Bristan ALP 1HBF C, Инструкции по установке и Руководство пользователя

Страница: 13 / 20

13
Installation Cont.
Wall Mounted Basin Mixer and Bath Filler
1. Remove the spout from the basin mixer / bath
filler by loosing the grub screw.
2. Decide on the final position of the basin mixer/
bath filler. Install suitable battons into the wall
cavity if required.
3. Secure the mixer body using the screws and wall
plugs supplied.
4. Plumb the hot and cold water supply pipes to
the required position and flush through to remove
any debris. Attach pipework to the hot and cold
inlets (hot on the bottom and cold on the right when
viewed from the front) ensuring the olive is fitted to
the copper pipe work. Tighten the compression nut
to secure pipework and create a water tight seal.
Note : Before finishing the wall surface turn on the
water supplies to check for any leaking connections.
5 . Finish the wall surface.
Note , it is important sufficient thread is left exposed
to allow the spout to connect.
6 . Attach the spout to the concealing plate using the
screws supplied.
7. Push the concealing plate / spout over the valve
shroud ensuring the O-rings on the spout
connecting tube have located inside the spout.
Tighten the grub screw on the under side of the
spout to secure in position.
8. Place the cartridge shroud over the cartridge and
push the shroud cover onto the cartridge shroud.
Tighten the grub screw.
10. Push the handle onto the cartridge and tighten
the grub screw.
11. Operate the basin mixer / bath filler to ensure it
is functioning correctly.
Cold
Hot
Shroud
Cover
Cartridge
Shroud