BriskHeat
®
Corporation. All rights reserved
3
TB4000 Bulb and Capillary
Temperature Controller
Inspect all components before use.
Do not use control and heater if any
component is damaged.
Do not repair damaged or faulty
controller.
Do not crush or apply severe physical
stress on any component of
controller, including cord assembly.
Unplug controller when not in use.
Unplug controller before fuse is
changed.
Failure to observe these warnings may result in
personal injury or damage to the heater.
IMPORTANT SAFETY INSTRUCTIONS
Do not immerse controller in liquid.
Keep volatile or combustible material
away from controller when in use.
Use controller only in approved
locations.
Keep sharp metal objects away from
controller.
Failure to observe these warnings may result in
electric shock, risk of fire, and personal injury.
End User Must Comply to the Following:
Only qualified personnel are allowed to
connect electrical wiring.
All electrical wiring must follow local
electrical codes and highly recommend
following NEC Article 427.
Final installation / wiring is to be inspected
by the authority who has jurisdiction in the
area that the heater and temperature
controller is installed.
The end-user is responsible for providing
a suitable disconnecting device.
The end-user is responsible for providing
suitable electrical protection device. It is
highly recommended that a ground fault
circuit breaker is used.
Failure to observe these warnings may result in
personal injury or damage to the heater.
A person who has not read and understood all
operating instructions is not qualified to operate
this product.
The controller does not use a
temperature sensor and therefore
satisfactory operation requires
occasional supervision under
changing load conditions
.
