BRIO CLBL720SC, Инструкция по эксплуатации

Страница: 7 / 12

7
E. Slide the water bottle into the dispenser
cabinet and close the door.
F.
with water before attempting to use the
dispenser.
G. Remove air from the tanks by placing
a cup under each water tap and drain
at least 4 cups (1 liter) of water before
initial use.
NOTE: Water will not pump from
the bottle until the door is
completely closed.
OPERATION
IMPORTANT: This unit has been tested and sanitized prior to packing and shipping. During
transit, dust and odors can accumulate in the tank and lines. Dispense and
dispose at least one quart of water prior to drinking any water.
Turn the Dispenser On/Off
IMPORTANT: Before you turn the dispenser on and activate the hot and cold switches, ensure
a bottle is installed.
1. Plug in the dispenser and turn the On/Off switch to On.
2. Run water through the tap until water begins to dispense.
3.
position. The cold water button on the front of the dispenser illuminates in blue indicating that
the dispenser is cooling water. The light turns off when the cooling process is complete.
4.
position. The hot water button on the front of the dispenser illuminates in red indicating that the
dispenser is heating water. The light turns off when the heating process is complete.
Set the Clock
1. Press and hold the up and down arrow buttons for 3 seconds until the clock display begins to
blink.
2. Press the cold water button to set the minute and the hot water button to set the hour. Use the
up and down arrow buttons to scroll until the correct minute/hour is displayed.
3.