MJ1023 GB Issue 01
6
5
DIGITAL CONTROL SYSTEM
The Ova-Easy Advance control system utilises highly accurate, individually calibrated sensors for
temperature and humidity. Be cautious of low cost analogue or digital thermometers and hygrometers when
comparing them with the incubator display readings.
5.1
NORMAL OPERATION
– Temperature and relative humidity are continuously displayed. Turning
status indicator shows if automatic turning is switched on or off.
The asterisk "*" adjacent to the temperature reading shows when the heater power is on. When
warming the asterisk will be continuously on, once warmed up the asterisk will slowly flash as the
heater is pulsed to maintain the correct temperature.
When reducing the temperature setting the asterisk may go off, this is normal. During periodic
incubation cooling (see sec
tion 11) the asterisk will be replaced by an arrow: “↓”.
The asterisk "*" adjacent to the relative humidity display is only on when the pump control output is on
(see section 8) and is only applicable when using the optional Brinsea Advance Humidity Management
Module.
If automatic turning is switched off "=" is shown in the corner of the display.
If automatic turning is switched on a line "/" symbol is shown revolving in the corner of the display.
5.2
POWER LOSS DISPLAY
– If power has been interrupted due to a power cut (or when first switching
on) a “P” is shown flashing on the bottom line of the display. Press OK for 2 or more seconds to clear
the indicator. If the reason for the power loss is not known check the power cable connections are
secure.
Onc
e the “P” indicator has been cleared, it is advisable to candle eggs a number of times to check for
losses.
T*37.5C
H*45% /
T*37.5C
H 45% P/