A017 GB Issue 04
8
4.11
Fit the water pot guard to prevent chicks jumping in. Small chicks may be at risk of drowning if
the water level rises in the pot.
4.12
Fit the egg disc with its ribbed side upwards and replace the lid. Choose the disc for smaller eggs if the
eggs can roll correctly when the disc is placed on a flat surface. If the eggs are too large they will be held
above the incubator base and will not turn.
4.13
Connect the humidity pump jack lead to the pump output socket on the rear of the incubator control
housing. Ensure the plug is fitted into the correct socket and pushed fully home.
4.14
Connect the power supply unit cable to the inlet on the back of the incubator lid. Ensure the connector is
pushed fully home in its socket.
4.15
Plug the power supply unit into a suitable outlet ensuring that the cable is not pulled tight. The incubator
fan will start, the buzzer sound and the LCD display on the temperature control housing will display the
air temperature and relative humidity.
4.16
Allow the incubator to run for at least an hour to stabilise the temperature before making adjustments or
setting eggs.
5 Digital Control System
The Mini Advance EX control system utilises a highly accurate, individually calibrated sensor for temperature.
Be cautious of low cost analogue or digital thermometers when comparing them with the incubator display
reading.
T*37.5C
H*29%
/
Power Supply
Inlet
Humidity Pump
Output Socket
