A015 GB Issue 05
3
DO NOT COVER THE INCUBATOR. FOR INDOOR USE ONLY. THE INCUBATOR MUST BE PLACED
IN AN AREA NOT SUBJECT TO SPLASHES OF WATER OR WET CONDITIONS AND OUT OF REACH
OF ANIMALS AND CHILDREN.
THIS INCUBATOR IS NOT A TOY AND MAY ONLY BE OPERATED BY CHILDREN UNDER ADULT
SUPERVISION.
FOR CONTINUED PROTECTION AGAINST FIRE AND ELECTRIC SHOCK ONLY USE THE POWER
SUPPLY UNIT AS SUPPLIED WITH THE INCUBATOR. Spares are available from Brinsea Products Ltd.
1 Unpacking
Your incubator has been supplied in protective packaging. Please remove all tape, strapping and packing from
the incubator and parts. Retain the carton and packing materials to enable the unit to be repacked.
Your incubator will include as standard:
Quantity
Item
1
Incubator (including removable lid)
1
Power Supply Unit
1
Water Pot Guard
1.1
Please identify each part and check that they are all present and undamaged. If there are any parts
damaged or missing please contact your retailer or Brinsea Products (at the address at the end of the
document).
1.2
To register your new Brinsea product please visit www.brinsea.co.uk and follow the link on the right
hand side of the home page to qualify for your free 2 year guarantee.
1.3
Go to www.Brinsea.co.uk and register as a free member of the Brinsea Email Group to receive the latest
news and information such as advance notice about new products, special offers, exclusive competitions
and much more.
2 Location and Installation
2.1
Your incubator will give best results in a room free from wide temperature variations and with generous
ventilation – particularly if several incubators are running at the same time. Ensure that the room
temperature cannot drop on a cold night. Ideally thermostatically control the room at between 20 and
25°C (68 and 77°F).
Never allow the room temperature to drop below 17°C (63°F) and ensure that
the incubator cannot be exposed to direct sunlight.
2.2
ONLY USE THE POWER SUPPLY UNIT SUPPLIED WITH THE PRODUCT. USE OF A
DIFFERENT POWER SUPPLY MAY CAUSE A HAZARD AND WILL INVALIDATE ANY
WARANTEE.
2.3
Connect the power supply unit cable to the socket on the back of the incubator lid. Ensure the connector
is pushed fully home in its socket.
2.4
Place the incubator on a flat, level surface that is resistant to moisture and scratches. The base of the
incubator must sit flat on the surface as this traps air under it as part of the thermal insulation.
2.5
Remove the lid and fill one of the two water pots with water or 100:1 Brinsea Incubation Disinfectant
Solution.
Fit the water pot guard to prevent chicks drowning.