L-1789E-F
11.
Step 9.
Step 8.
58
9
5/16" Nylon Lock Nut
Qty. 2
51
5/16" Flat Washer
Qty. 4
45
5/16" x 2-1/2", Hex Bolt
Qty. 2
45
33
51
54
57
9
53
56
52
56
50
54
“J” Channel
53
Snap
“J” Channel
a) Locate and align the holes in the upper rear
tube (53) with the side tubes (56). Locate and
align the holes in the lower rear tube (53) with
the bottom tube (52).
b) Stand in the bottom of the hopper. Insert
the end of the spring rod (58) into the lower
holes aligned in step a. Pull up on the upper
rear tube (53) and insert the other end of the
spring rod (58) into the upper holes.
Please note that this step must be done with
eye protection (safety glasses) and gloves as
the spring rod requires some force to install.
After installation the spring rod will be slightly
bent.
a.) Attach pull rope(50) to the middle of rear tube(53).
b) Attach hamper mount tube (57) with hex bolts, washers, and lock nuts as shown. Do not
overtighten. Hamper mount tube must be free to pivot. Attach Vinyl Cap (33) to hamper mount
tube (57) as shown.
c) Pull up the bottom of the hamper, and snap the “J” channel of the hamper bottom to the
hamper stop rod (54). Secure the snaps as shown. bent.
d) Attach the Lock Nuts (47) to the Hamper Stop Rod (54).
47
3/8" Hex Lock Nut
Qty. 2
47
47
