10
1019097-D
English Manual
NOTE: The Square Bearings must be completely inserted into the end panels.
3. Push the End Panels (
1
) toward the center until there is no free play along the
shaft. Tighten the six nuts (
A
) securing these panels fully.
1.
WEARING GLOVES:
Slide the 10 Tines (
5
)
and 20 Bearings (
6
) onto the
Tine Shaft (
2
) as illustrated.
NOTE: Round projections on Bearings (
6
) must
fit into holes in Tines (
5
) and into two holes of
opposite Bearing.
2. Push a Square
Bearing (
17
) into the
End Panel (1).
Place a 5/8” Flat
Washer (
15
) on the
Tine Shaft (
2
) and slide
the shaft through the
end panel.
Step 4-B
ASSEMBLY
CAUTION: GlOves Are reqUIred.
Tines have extremely sharp points. Use caution when working around them.
5
2
6
6
A
A
